Reduce risk and maintain compliance with our specialist risk management services.
We’re proud to be a leading provider of complete life cycle risk management solutions. From ensuring asset safety and legal compliance with our thorough engineering inspections to driving operational efficiency with our specialist non-destructive testing services, (and much more in between), we’re proud of the long-lasting partnerships we have formed with our customers over the last 160 years, based on the value of our solutions.
Sector
Marine
Location
United Kingdom
Services
Vibration Analysis
Remote Monitoring and Data Services
Our partnerships within the Marine sector
Overview
Vibration data from a vessel identified a bearing defect on an aux boiler feed pump.
Upon investigation of the bearing, it was noticed that the bearing had significant oxidation across the surface of the bearing cage. The bearing was replaced, avoiding unexpected downtime and possible catastrophic pump damage.
The challenge
We carry out routine periodic vibration analysis for a global shipping company. The vessel’s engineers collect vibration data on all of their equipment within the vibration programme on a three-month basis and send the data to the Group’s dedicated remote analysis centre for detailed analysis.
Upon receipt of baseline vibration data from a vessel, it was noted that overall acceleration levels on an aux boiler feed pump were significantly elevated at the pump NDE. Associated spectral data showed a dominant frequency with harmonics relating to an outer race defect frequency of the bearing. Furthermore, the time waveform at this location was showing Pk-Pk values of greater than 80g.
Typically, this behaviour is indicative of a bearing fault likely caused by a lubrication deficiency over the bearing. Continuous operation of the pump in this condition would likely lead to bearing failure and/or damage to the wider steam condensate system.
The solution
Initially, our engineers recommended that the pump bearings should be lubricated at the earliest convenience and further data should be sent for analysis.
Feedback was received from the vessel where the onboard engineers advised that lubrication was carried out and data sent. Upon analysis of this data, it was evident that the bearing defect was still present, and the bearing would likely need replacing at the earliest opportunity.
The result
Feedback was received and the vessel’s maintenance personnel informed our engineers that the pump NDE bearing was replaced with a new spare.
Figure 1: New (left) vs old (right) bearing. Corrosion on bearing cage can clearly be seen with visible spalling on the raceways.
Upon inspection of the old bearing, it was noticed that the bearing had significant oxidation across the surface of the bearing cage (figure 1), which contributed to the elevated bearing frequencies seen in the enveloped data (figure 2).
New data was received after the bearing replacement, showing a marked improvement in vibration levels at the pump NDE.
Figure 2: An outer race fault frequency (BPFO) with harmonics in the envelope spectrum of the pump NDE.
As the vessel was within the warranty period, timely analysis and recommendations for rectification resulted in zero cost implications for the client.
Key outcomes
Cost avoidance of £3,000.
Identified bearing defect on aux boiler feed pump from vibration data.
Recommended lubrication and further data analysis.
Bearing defect still present after lubrication, recommended bearing replacement.
Bearing replaced and vibration levels improved.
No cost implications for the client as the vessel was within the warranty period.
Speak to us about our industry leading Condition Monitoring solutions
Related Case Studies
View All Case Studies
Preserving History and Ensuring Safety with Structural Monitoring During The Jenners Building Re-development
Read more.
Vessel Downtime Avoided for UK Ferries Operator
Read more.
Testing Subsea Air Bags with SmartLoad® Load Monitoring Technology
Read more.